S-F Graffiti Transfers v.3 (6)

DISCONTINUED PRODUCT

Set of 6 (2 of each design) waterslide S-F Graffiti Transfers v.3

Fits perfectly the F00048 Pickle Vans (3).

Important: The colours may vary a bit from those shown in the picture depending on the undercoat.

1. We strongly recommend to paint the surface of the terrain piece with gloss varnish before applying the transfer.

2. Dip the transfer in water for around 30 seconds.

3. Delicately slide the transfer off the paper onto the terrain piece using finger or brush.

4. Make sure no air is trapped beneath the transfer.

5. After the transfer is completely dry [around 12 hours] you may gently remove the film.

6. Seal the transfer with matt varnish for best effect.

DISCONTINUED PRODUCT:
The manufacturer of the product has decided to stop manufacturing it, so once the last units are gone, it won't be available again. If you want the product, take the chance while supplies last.