S-F Graffiti Transfers v.3 (6)

PRODUCTO DESCATALOGADO:
Que un producto esté descatalogado significa que el fabricante ha decidido dejar de producir dicho artículo, por lo que una vez agotadas existencias no volverá a estar disponible. Si quieres este artículo, aprovecha para comprarlo mientras tengamos unidades en stock.

Set of 6 (2 of each design) waterslide S-F Graffiti Transfers v.3

Fits perfectly the F00048 Pickle Vans (3).

Important: The colours may vary a bit from those shown in the picture depending on the undercoat.

1. We strongly recommend to paint the surface of the terrain piece with gloss varnish before applying the transfer.

2. Dip the transfer in water for around 30 seconds.

3. Delicately slide the transfer off the paper onto the terrain piece using finger or brush.

4. Make sure no air is trapped beneath the transfer.

5. After the transfer is completely dry [around 12 hours] you may gently remove the film.

6. Seal the transfer with matt varnish for best effect.